New Step by Step Map For winchester primers wlp

New Step by Step Map For winchester primers wlp

Blog Article

I’m liking this load I made Along with the similar load data apart from I’m making use of sixteen.8 of Clays and loading it with 1oz. Would that insert or lessen pressure and velocity?



The Winchesters are good nonetheless from what I've observed the CX2000 primer appears to be hotter, They can be both of those with regards to the identical in reliability.

The 209 primers are meant to give stress towards the powder, which aids in preserving a constant velocity and lowering the development of gun rings generally.

The main distinction between Cheddite 209 primers and Federal 209A primers is of their electricity and sensitivity.

These primers function well which has a total-powered regular revolver or magnum, plus the shot assortment is noticeably higher than triple seven.

I feel these kinds of deformation is going on if/in the event the thingy at depriming/sizing station is just too "very low". I set up it up and afterwards by some cause it "unsrewed" anything within, so I monkeyed all-around and acquired exact same success - dished/bulged bases. They shot okeish, with none challenges.

The new Hodgdon Clays family is a perfect example of that, - it will not even appear to be the outdated Clays.

My only other advise to you will be to count on examined data, rather then using unpublished loads from other reloaders.

i.e. during the properly sane Remington hull load circled in crimson that may be a cushty 10,000 PSI by using a W209, what would the influence be towards the primer battery cup (button?) deal with if you merely switched from the W209 into a Ched 209 w/o reducing powder ?

If the loading lead target loads and also your not at max, and loading shells for gauge specific barrels I'd personally say you’re great to swap them.

I have utilized primarily cheddite primers but have utilized a number of Winchester primers with no complications or changes on my MEC 9000 loading Remington and Winchester hulls.  

010" interference . The hull is held down with the rim since the seating put up is pushing up on to start with the primer and in the end the bottom area in the hull, consequently the desperation in th head stamp space The appears about .010". Most reloads will see resistance seating win20s in as soon as fired rem hulls.

Not so new member outdated aka prior to transferring to KY was Ohio Wildfowler ( was a moderator on a couple discussion boards)

5 700X and claybuster wads with 11/eight load in AA hulls. I went to one of many huge retailers and they only had Federal primers and at home I discovered that they winchester 777 209 primers had been 209A's. Am i able to utilize them are they equivalent.